NOTE: THIS IS FINE FOR SOUTHERNS, BUT NOT FOR SCREENING BY PCR. (from Ruixia, 7/99, from protocol by Stef Oehen 7/94). 1. Put 1 cm tail in 1.5 ml microcentrifuge tube. 2. Add 500µl Tail Buffer and 30 µl Proteinase K. (see recipes below). 3. Incubate O/N at 55℃ (or 4 hours minimum). 4. Mix well by shaking by repeated inversion. Do NOT vortex. 5. Let cool to room temperature. 6. Pre-Spin (to get rid of fur) 8 min (usually 4℃, TRm ok). 7. Pour supernatant into a clean tube (numbered). (Toss out furry tube). 8. Add 250 µl saturated NaCl (~6M) and invert to mix (don't vortex) to precipitate the proteins. 9. Let sit for 5 minutes at room temperature. 10. Centrifuge max speed in microfuge (~13000 rpm), 10 min at 4℃, to spin down the protein. (TRm is ok, but 4℃ is much better). 11. Pipet supernatant into a fresh tube. Avoid transferring the white precipitate. 12. Add 500µl isopropanol. 13. Mix by inversion until a white thready material is visible (DNA!). Shake until thread doesn't get any bigger, ~ a minute. 14. Centrifuge max speed in microfuge (~13000 rpm), 10 min (TRm is ok). 15. Pipet off the sup, being careful not to disturb the pellet (DNA). 16. Wash pellet with 70% EtOH (100-800 µl). Vortex briefly. 17. Centrifuge 6 minutes. 18. Pipet off the sup, being careful not to disturb the pellet (DNA). 19. Tap/Drain tube onto a kimwipe. 20. Air Dry for 45-60 min. (Do NOT use Speed-Vac). 21. Dissove the pellet in 100µl Tris (10mM Tris, or useTE) containing RNase. 22. Let dissolve O/N at 4℃. IMPORTANT- DON'T SKIP THIS STEP! Mix well. Measure OD260 or OD260/280. Use 20 µl for Southerns, or check [DNA] and use 10mg. Tail Prep Solutions(non-phenol prep.) RNase: 10 mg/ml. Use 20µ RNase per 1 ml Tris. Proteinase K (Sigma #63173): 10 mg/ml in H2O, (activate 1 hr at 37℃ before use). Saturated NaCl: Add NaCl to approximately 6M (35g/100ml). Tail Buffer Stock Reagent Vol. For 100 mls Final Shirley Reynolds |
→如果您认为本词条还有待完善,请 编辑词条
上一篇克隆,人体IL-8DNA的表达与活力检测 下一篇基因工程简介
词条内容仅供参考,如果您需要解决具体问题
(尤其在法律、医学等领域),建议您咨询相关领域专业人士。
0